Kong Gateway OSS [ARCHIVE]
0.6.x
5-minute Quickstart
Introduction
Before you start: Make sure you've installed Kong — It should only take a minute!
In this section, you’ll learn how to manage your Kong instance. First we’ll have you start Kong giving you access to the RESTful Admin interface to manage your APIs, consumers, and more. Data sent through the Admin API is stored in your Cassandra instance or cluster, meaning you must have Cassandra running before starting Kong.
Note: If you haven’t already, go ahead and make sure that you have a Kong configuration file located under /etc/kong/kong.yml
and points to your Cassandra instance or cluster. If you haven’t, consult the configuration reference before starting.
1. Start Kong.
Issue the following command to [start][CLI] Kong:
```bash
$ kong start
```
**Note:** The CLI also accepts a configuration (`-c <path_to_config>`) option allowing you to point to different configurations.
2. Verify that Kong has started successfully
The previous step runs migrations to prepare the Cassandra keyspace.
Once these have finished you should see a message (`[OK] Started`) informing you that Kong is running.
By default Kong listens on the following ports:
`:8000` - Proxy layer for API requests
`:8001` - [RESTful Admin API][API] for configuration
3. Stop Kong.
As needed you can stop the Kong process by issuing the following [command][CLI]:
```bash
$ kong stop
```
4. Reload Kong.
Issue the following command to [reload][CLI] Kong without downtime:
```bash
$ kong reload
```
Next Steps
Now that you have Kong running you can interact with the Admin API.
To begin, go to Adding your API ›